How to Fix HP Printer Error 59.F0? [3 Easy Solutions]

Reasons for the HP 59.f0 Error

Here’s why the error 59.f0 occurs on an HP printer;

• Transfer alienation failure
• Failed fuser driver assembly
• Defective ITB (can’t rotate)
• Faulty SR9 sensor
• Hardware failure
• Paper jams

How to Fix the HP Printer Error 59.f0?

Follow these solutions to resolve the HP 59.f0 error;

Solution 1: Reset the Printer

Here’s how to reset the HP printer;

1. Begin by resetting the printer to its default settings.
2. Access the printer’s control panel or settings menu and look for the reset option.
3. Follow the on-screen commands to complete the reset process.
4. Now disconnect the printer from any surge protector or power strip it may be connected to.
5. Plug-in the HP printer directly into a wall outlet to ensure a stable power source. Power fluctuations or issues with the surge protector can sometimes cause errors like 59.F0.
6. Finally, power on the printer and perform a test print.

Solution 2: Reset the Intermediate Transfer Belt (ITB)

Follow these steps to reset the ITB;

1. Power off the HP printer and unplug it from the power source.
2. Locate the ITB assembly that is usually located near the toner cartridges.
3. Gently remove the ITB assembly from the printer.
4. Carefully disconnect any cables or connectors attached to the ITB.
5. Leave the ITB disconnected for a few minutes to ensure a complete reset.
6. Reconnect the cables and connectors to the ITB.
7. Insert the ITB assembly back into its original position in the printer.
8. Check the internal connections for proper functioning. Specifically, inspect the connection between the ITB and the transfer-roller-disengagement sensor located at connector J19.
9. Ensure there’s no loose connection between the ITB and the DC controller PCA (connector J128).
10. Plug-in the printer back into the power source and power it on.

Solution 3: Test the Intermediate Transfer Belt (ITB)

Follow these steps to test the ITB on an HP printer;

1. Completely remove the ITB from the printer.
2. Manually rotate the gear and observe any fluctuations in the flag as you turn the white gear.
3. If the flag appears damaged or shows irregular movement, replacing the ITB is recommended.
4. In case the ITB gear and flag are working correctly, it’s important to examine the Sensor SR9.
5. Remove the ITB gear and locate the Sensor SR9 situated inside the ITB cavity.
6. Access the printer’s control panel and press the ‘Home‘ button.
7. Use the down arrow to highlight the diagnostics menu and press okay.
8. Select the Manual Sensor Test and click OK.
9. Within the ITB cavity, release the SR9 flag and monitor the display for the sensor response as you press the flag.
10. The sensor must toggle between 0 and 1. If there is no toggle, it indicates a faulty sensor that needs replacement.

If further assistance is needed, it’s recommended to consult the printer’s manual or reach out to HP support.

FAQ

How can I prevent HP printer Error 59.F0 from recurring?

To minimize the chances of encountering this issue in the future, ensure regular maintenance of your printer. Keep it clean, avoid paper jams, use high-quality paper, and follow proper printer usage guidelines. Additionally, staying updated with the latest firmware and drivers can also help prevent such errors.

Conclusion

We hope you can now print without any hassle. If the HP 59.f0 error doesn’t resolve, contact HP support and send them pictures along with your complaint so the experts can handle the problem.